Fiat New 500, Owner'S Handbook Manual, Page: 35 / 320

33
B
C
26
F0S1295
Backrest angle adjustment
Rotate the lever (C) fig. 26.
Reclining the backrest
7)
To fold the backrest over, adjust lever
(D) fig. 27 (movement 1) and push
the backrest forwards until it locks
(movement 2).
Then release lever (D) and, pushing on
the backrest, slide the seat forward
(movement 3).
27
F0S1365
Driver side and passenger side,
with position memory
To bring back the seat in its initial
position proceed as follows:
slide the seat back by pushing in the
lower part of the backrest as indicated
in fig. 27, taking care not to lift the
backrest into the vertical starting
position. In this way, slide the seat to
the locked position (movement 4);
now lift the backrest (movement 5)
into the vertical starting position until
you feel the click;
WARNING Using lever (D) fig. 27 before
locking the seat in its initial position will
cause the initial seat position to be lost.
In this case the position of the seat
must be restored through lengthwise
adjustment lever (A) fig. 25.
Heated seats
(where provided)
Heated seats can only be activated by
soft touch controls on the Uconnect™
system with the ignition device in the
START position.
Auto On comfort
(where provided)
The electric heated steering wheel
is switched on automatically
whenever the motor is started and
the external temperature is lower
than or equal to 4.5
°
C. This function
is activated/deactivated on the
Uconnect™ system (see "Settings" in
the"Vehicle mode" paragraph in the
"Multimedia" section).
REAR SEATS
EXTENDING THE BOOT
18)
7)
The separate rear seats allow partial
fig. 28 or total fig. 29 boot extension.
28
F0S1345
29
F0S1346