Fiat DOBLO 2015, Owner'S Handbook Manual

Page: 125 / 244

123
HAZARD WARNING
LIGHTS
They are turned on by pressing switch
(A) fig. 153, regardless of the position
of the ignition key. Warning lights
and
are lit up in the instrument
panel when this device is activated.
Press the switch (A) again to turn the
lights off.
WARNING The use of hazard warning
lights is governed by the highway code
of the country you are in. Comply with
legal requirements.
153
F0V0513
Emergency braking
(for versions/markets, where provided)
In the event of emergency braking
the hazard warning lights come on
automatically, as do the
and
warning lights in the panel.
The function switches off automatically
when the nature of the braking
changes.
REPLACING A BULB
GENERAL
INSTRUCTIONS
Before replacing a bulb check the
contacts for oxidation;
burnt bulbs must be replaced by
others of the same type and power;
always check the height of the
headlight beam after changing a bulb,
for reasons of safety;
when a light is not working, check
that the corresponding fuse is intact
before changing a bulb. For the
location of fuses, refer to the paragraph
“If a fuse blows” in this section.
117) 118)
37) 38)
WARNING A slight misting may
appear on the internal surface of the
headlight: this does not indicate a fault
and is caused by low temperature
and the degree of humidity in the air.
Misting will rapidly disappear when
the headlights are switched on. The
presence of drops inside the headlights
indicates infiltration of water. Contact a
Fiat Dealership.
BULBS TYPES
Various types of bulbs are fitted to your
vehicle fig. 154:
154
F0V0027
A Glass bulbs: clipped into position.
Pull to extract.
B Bayonet type bulbs: to remove
from its holder, press the bulb, turn it
anticlockwise, then remove.
C Tubular bulbs: release them from
their contacts to remove.
D Halogen bulbs: to remove the
bulb, release the clip holding the bulb in
place.
E Halogen bulbs: to remove the bulb,
release the clip holding the bulb in
place.