Fiat 500X2017, User Manual

Page: 88 / 228

PARKVIEW REAR BACK UP CAMERA — IF EQUIPPED
The ParkView Rear Back Up Camera that allows you to see an on-screen image of your
vehicle's rear surroundings when the gear selector is put into REVERSE
. The image will
be displayed on the touchscreen display along with a note to “check entire surroundings”
across the top of the screen
.
After five seconds this note will disappear
.
The ParkView
camera is located above the rear license plate
.
When the vehicle is shifted out of RE-
VERSE (with camera delay turned off), the
rear camera mode is exited and the naviga-
tion or audio screen appears again
.
When the vehicle is shifted out of RE-
VERSE (with camera delay turned on), the
camera image will continue to be displayed
for up to 10 seconds after shifting out of
REVERSE unless the vehicle speed exceeds
8 mph (13 km/h), the vehicle is shifted into
PARK or the ignition is switched to STOP
mode
.
A touchscreen button to disable the cam-
era is available when the vehicle is not in
REVERSE
.
Display of the camera image
after shifting out of REVERSE can be disabled via Uconnect Settings .
When enabled, active guide lines are overlaid on the image to illustrate the width of the
vehicle and its projected backup path based on the steering wheel position
.
When enabled, fixed guide lines are overlaid on the image to illustrate the width of the
vehicle
.
Different colored zones indicate the distance to the rear of the vehicle
.
The following table shows the approximate distances for each zone:
Zone Distance To The Rear Of The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 3 ft (30 cm - 1 m)
Green 3 ft or greater (1 m or greater)
NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth
. Do not cover the lens .
Parking Camera
OPERATING YOUR VEHICLE
86