Fiat 500X2017, User Manual

Page: 16 / 228

KEYLESS ENTER-N-GO — IGNITION
NOTE:
In case the ignition switch does not change with the push of a button, the key fob may
have a low or dead battery
.
In this situation, a back up method can be used to operate
the ignition switch
.
Put the nose side of the key fob (side opposite of the Emergency
Key) against the ENGINE START/STOP button and push to operate the ignition switch .
Engine Starting/Stopping
Starting
1 . With a valid key fob inside the vehicle .
2 . Place the gear selector in PARK or
NEUTRAL
.
3
.
While pushing the brake pedal, push the
ENGINE START/STOP button once
. If
the engine fails to start, the starter will
disengage automatically after 10 sec-
onds
.
4 . To stop the cranking of the engine prior
to the engine starting, push the button
again
.
NOTE:
In case the ignition mode does not change
with the push of a button, the key fob may have a low or dead battery
.
In this situation, a
back up method can be used to operate the ignition . Put the nose side of the key fob
against the ENGINE START/STOP button and push to operate the ignition .
Stopping
1 . Place the gear selector in PARK .
2
.
Push the ENGINE START/STOP button once
.
The ignition will return to the OFF
mode .
NOTE:
If the gear selector is not in PARK, the ENGINE START/STOP button must be held for
two seconds and vehicle speed must be above 5 MPH (8 km/h) before the engine will
shut off.
Engine Start/Stop Button
GETTING STARTED
14