Festo Checkbox Compact CHB-C-X, Manual

Page: 119 / 148

A. Technical appendix
A−7
Festo P.BE−CB−COMP−en en 0503c
Code Remedy Cause
Recognition fault
E 20 The nominal orientation cannot
be distinguished from other
orientations, because e.g.:
the parts orientations were
swapped by mistake during
the teach procedure,
or
the nominal orientation is
too similar to other orienta
tions.
·
Repeat the teach procedure. Pay attention to the
positioning of the sample parts in accordance with the
orientation shown.
·
Optimize the Teach data with the CheckOpti software.
Data fault
E 40 The Teach data are not clear.
When the device is switched on
again, the saved Teach data are
no longer OK. Repeat the Teach procedure.
Check the environment for devices which do not
conform to CE requirements.
Make sure that all electrical connections are correctly
wired.
E 41 The controller has lost the
system parameters With CheckKon: Load system parameters again.
Contact the Festo after−sales service.
E 42
The controller has lost the
configuration part of the Teach
data. With CheckKon: Load Teach data again.
Contact the Festo after−sales service.
E 43 The Teach data are not
compatible.
The Teach data are not
organised compatibly for the
Checkbox used. Use compatible Teach data format.
Repeat the Teach procedure.
Tab.A/2: Fault codes
If the hardware fault message
ţ
E60 appears, please contact
the Festo after−sales service.