Festo Checkbox Compact CHB-C-X, Manual

Page: 116 / 148

A. Technical appendix
A−4
Festo P.BE−CB−COMP−en en 0503c
A.1.2 Fault messages and warnings
The Checkbox stops automatically if there is a fault. When the
cause of the fault has been eliminated, fault messages/warn
ings must be quitted before the Checkbox can start again.
1. Eliminate cause of fault
2. Quit the fault message: Press the START/STOP button
3. Start the Checkbox: Press the START /STOP button
Depending on the customer−specific design of the Checkbox
or configuration with CheckKon, the following faults will not
be shown:
The fault messages E 01, E 02, E 04, E 06, E 08, E 12,
E 14 can be deactivated.
Fault E 05 is redefined as warning F05 or deactivated.
Faults E 08 and E 14 are only shown with encoder mode.
Fault E 06 is shown only if the CheckKon function Forced
abort of analysis" is activated.
Please note
If fault messages and warnings are deactivated, undefined
operating states and malfunctioning can occur in the event
of a fault. Before deactivating, check whether additional
measures are necessary for avoiding faults.