Fervi T066, Operation And Maintenance Manual

Page: 30 / 44

MACHINES AND
ACCESSORIES
Page 30 of 44
10.2Drilling in manual mode
Unscrew the knob to loosen the worm screw cone and the spring base. Then set the stroke of
the spindle by setting the positive depth of the blind holes (depth gauge) or through holes.
1. Choose an appropriate tool for the next process and insert it between the jaws of the
spindle.
2. Secure the tool by tightening the spindle with the key provided.
Mounting the tool
Make sure that the tool is properly and securely assembled before starting the machine.
Locking the table
Before starting drilling/tapping, lock the table using the lever and bolts that hold the table in
position as described in Chapter 5.
3. Set the speed of rotation of the spindle (and tool) depending on the operation to be
performed, positioning the switch and levers accordingly as described in paragraph 5.2.
4. Secure the workpiece on the work surface using the slots on the table or the vice.
5. Adjust the height of the work surface, as well as its rotation.
6. Lock the table using the lever, as shown in paragraph 5.2.
7. Close the spindle's interlocked guard protection.
8. Turn on the drill and start rotation by moving the switch to
the D
RILLING
position (ref. 2 in Figure 5) and pressing the
R
IGHT
button.
9. Lower the spindle using the hand-wheel for vertical
displacement and drill the hole.
10. When finished, release the wheel.
Figure 18 – Normal start.
Drilling depth
Check the drilling depth against the graduated scale on the ring nut.
Automatic Tapping and Drilling
Only carry out tapping operations at low rotation speeds of MAX 150 rpm.
fervi.com