Ferrari 2012 F12 Berlinetta, Owner'S Manual

Page: 16 / 266

16
General
While driving, with the ignition key in position
II
:
1) If the CODE warning light A turns on, it means that the system
is performing a self-diagnostic cycle. At the first opportunity,
you can stop and test the system: switch off the engine by
turning the ignition key to position
0
, then turn the key back to
position
II
. The CODE warning light A will turn on and should
go off within one second. If the warning light stays on, repeat
the procedure described previously leaving the key at
0
for
more than 30 seconds.
Important note
If the problem persists, please contact the Ferrari Service
Network .
2)
If the
CODE
warning light
A
flashes, it means that the vehicle is
not protected by the immobiliser.
Important note
Each key provided has its own specific code, which must be
stored in the memory of the system control unit.
Important note
Contact the Ferrari Service Network immediately to have all
the keys stored in the system memory.
Duplicating the keys
If you request additional keys, provided that the conditions to
satisfy your request are met, remember that the codes must be
stored (up to a maximum of 7 keys) on all the keys.
Contact the
Ferrari Service Network directly and bring the
following with you:
- all the keys in your possession;
- the CODE CARD for the
Ferrari CODE system;
- a personal identity document;
- the documents proving ownership of the vehicle;
- a report of loss of keys made to the relevant authorities.
The codes for the keys that are not available when the new
memorisation procedure is performed will be deleted from the
memory to prevent any lost or stolen keys being used to start the
vehicle.
B
A