8
GB
Congratulations on having chosen the VEGA cats and small
dogs fountain. It has been designed by Ferplast to promote
healthy pets, encouraging them to drink more. Using it will be
very easy. You will need only a few minutes for product
maintenance to keep the water always clean and crystal clear.
READ THE INSTRUCTIONS CAREFULLY
BEFORE USING THE PRODUCT
• The appliance is only to be used with the
adaptor provided.
• Ensure that the voltage shown on adapter
corresponds to that of your home electrical
power supply.
• Disconnect the appliance from the power sup-
ply before carrying out any maintenance work.
• Do not connect the pump to the power supply
before filling the bowl with water.
• Keep the appliance and its cord out of reach of
children less than 8 years.
IMPORTANT: never leave the pump
working without water!
• The temperature of the water must not
exceed 35° C.
• The water level should always be over the
minimum water level shown on the product.
• The power cable of the pump and of the
adapter cannot be repaired or replaced: if
damaged, the whole appliance (pump and
adapter) must be replaced. Never cut the
power cable.
• The product is intended only for indoor use.
• Connect the plug to your electric power sup-
ply leaving a loop in the cable below the
electrical socket to prevent drops of water
running down the cable and into the power
supply.
• Before switching on make sure your home is
protected by an automatic safety breaker
switch (or individual breaker plug) with an
operating current of no more than 30 mA.
• This appliance may be used by children aged
8 and over and by people with reduced phys-
ical, sensory or mental capabilities or with a
lack of sufficient experience and/or knowl-
edge, provided they are supervised or have
been trained in the safe use of the appliance
and understand the potential dangers.
Children must not be allowed to clean the
appliance unless they are supervised. Children
must not play with the appliance.
• This fountain for cats and small dogs must
only be used for its intended purpose.
• Ensure that the power cable is placed where it
cannot be bitten or damaged by your pet.
• Please ensure that children do not drink from
the fountain. Never put any poisonous sub-
stances or supplements (e.g. scented oils) in
which could accidentally be ingested by chil-
dren or pets.
• There is a risk of electric shock if electronic
devices come into contact with water. While
the fountain is in use, it may occasionally
cause water to be splashed. Therefore, do not
place the fountain on top of an electronic
device. Position it so that if it is bumped or
knocked over accidentally, the water or
splashes that come out cannot come into
contact with electronic devices.
IMPORTANT
- Within the European Union, a crossed-out wheel-
ie bin symbol on the product, documentation or pack-
aging indicates that the product cannot be disposed of
in the regular household waste stream, in compliance
with EU Directive 2012/19/EC and with current local
regulations. The product must be disposed of at recycling centres
or authorised waste disposal centres for electrical and electronic
equipment, in accordance with current legislation in the country
where the product is found. Incorrect disposal of this type of waste
can have a negative impact on the environment and human health,
caused by the potentially hazardous substances produce by elec-
trical and electronic equipment. Correct disposal of these products
will also contribute to the efficient use of natural resources. Further
information is available from the product retailer, the competent
local authorities and national manufacturer’s organisations.
Installing the product
• Connect the pump to the pipe on the inside of the upper part of
the fountain (
1-2
) and press it down firmly.
• Insert the power cable through the hole in the rear part of the
fountain (
3
).
• Put the 4 rubber feet in their cases on the bottom of the bowl
(
4
).
• Before inserting the active carbon filters, rinse them under tap
water in order to remove dust and excess carbon (
5
).
• Attach the slide to the bowl (
6-6a
).
• Insert the power cable through the hole hole in the rear part of
the bowl (
7
).
• Fill the bowl with water.
• Connect the power cable to the adapter and plug it into the
main socket.
IMPORTANT: never connect the pump to the power
supply before filling the bowl with water.
How to adjust the pump flow rate
• Disconnect the pump power cable from the adapter.
• Take the slide away from the bowl by carefully pulling it
upwards (
8
).
• Adjust the flow rate by using the small lever (
11
).
• Reassemble the product following the steps in the reverse.
981225-3_FI VEGA_A6.indd 8
28/11/16 13:57
Summary of Contents for VEGA
