11
EN
4.4
CUTTING CAPACITY (Fig. 10)
The table below specifies the cutting capacity at 90 and 45
degrees which may be obtained in normal conditions of use
described in this manual and without placing any other
object between the jaws of the clamp.
0° = Ø 85 mm; 85 mm; 85x 105 mm
45° = Ø 70 mm; 60 mm; 60 x 70 mm
4.5
CORRECT POSITIONING OF THE PIECE IN
THE CLAMP (Fig. 11)
The pieces to be cut should be fitted directly between the
jaws without adding other objects.
Fig. 11
ATTENTION: Never hold the pieces to be cut in
your hand.
When the pieces to be cut are profiled sections, flat pieces
or special shapes, refer to the examples shown in the
figures.
If the thickness of the profiled section is to be very thin,
an outline should be fitted which copies the profile inside
the profiled section itself to stop it being crushed between
the jaws.
4.6
CUTTING TABLE
For special requirements (see cutting table point 4.6), for
example, for cutting large solid sections or profiled sections
or corner pieces of small thickness, there are also blades
avail-able with 6, 14 or 18 teeth per inch.
MATERIAL: .......... M42 (acciaio per molle + acciaio HSS)
EXTENSION : .................................................... mm 1330
HEIGHT: ................................................................ mm 13
THICKNESS: ..................................................... mm 0,65
TOOTHING: ............................................... standard 8/12
............................................................... optional 6-14-18
6
MAINTENANCE
6.1
REGULAR MAINTENANCE
The operations of ordinary maintenance, which may also
be performed by non-specialist personnel, are all described
in the previous sections and here below.
1. Before performing any maintenance operation,
disconnect the machine electric plug from the wall
outlet.
2. During maintenance operations, always wear personal
protection (safety goggles and gloves).
3. Remove the processing residues from the cutting area
and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
ATTENTION: Do not use jets of compressed air.
4. If you do not intend to use the sawing machine for a
long time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the blade
so that it is not kept tight for no reason.
6.2
ASSISTENCE
Should it be necessary to call qualified personnel for
operations of extraordinary maintenance, or in the case of
repairs, under guarantee or at a later date, you should
always contact an authorized service centre or the factory
directly, if there is no service centre in your area.
6.3
DISPOSAL OF THE MACHINE, PACKING
At the end of the machine life, if the
machine must be scraped, contact
an authorised waste disposal centre
in order to comply with the Standards
for hygiene and environment
safeguard.
The packing must be disposed of
according to the ruling standards by
delivering it to authorised people for
the collection, disposal or reclaim.
Please contact the ASSOCIATION OF USED OILS near
to you.
5
ACCESSORIES
5.1
CHOISE OF BLADE
Your sawing machine is equipped with a bi-metal blade
measuring 1330x13x0.65 mm with variable toothing 8/12
teeth per inch, for use in the majority of cuts possible with
this machine.
2002/96/EC
All manuals and user guides at all-guides.com
