Felo FW-06, Service Manual

Page: 33 / 134

Spot Inspection and Adjustment
Service Manual 29
■
Spot inspection and lubrication of var-
ious wiring harnesses
Place the motorcycle vertically on a flat and hard
surface.
1. Perform the following spot inspection:
• External pull cable
If the external pull cable is damaged, promptly
replace it.
2. Perform the following spot inspection:
• When the wiring harness does not operate
smoothly, promptly lubricate it.
■
Spot inspection of the switch/light/signal
Check if all switches and lights work normally. If any
abnormal situation is found, promptly repair it.
■
Drive belt
1. Perform a spot inspection of the following contents.
Perform a spot inspection of the drive belt
A. Cracked outer teeth → Replace it with a new
one
B. Tooth surface defect → Replace it with a new
one
C. Worn convex surface → Replace it with a new
one
D. Damage caused by foreign objects entering
the gears → If the front end is damaged, please
make a replacement.
E. Cracked inner tooth (fine cracks) → The
motorcycle can be ridden normally, but a spot
inspection is required to check its operating
status.
F. Small cracks (slight cracks) → The motorcycle
can be ridden normally, but a spot inspection is
required to check its operating status.
G. Burrs on teeth → The motorcycle can be
ridden normally, but a spot inspection is required
to check its operating status.
Wear on the inclined part (only the outer end is
worn.)
H. → The motorcycle can be ridden normally, but
a spot inspection is required to check its operating
status.
A B
C D
E F
G H