Felo FW-06, Service Manual

Page: 26 / 134

Spot Inspection and Adjustment
22 Service Manual
■
Discharge air from the rear brake sys-
tem and replace the brake fluid
Discharge air and replace the brake fluid according to
the following procedure:
1. Open the cover of the upper brake pump, remove
the rear lower brake pump, and place a special
partition between brake pads.
2. Insert the drain hose to the lower brake pump drain
bolt.
3. Tightly hold and then release the brake handle 3-5
times to exert force to the brake oil pipe (adjust the
frequency of holding and releasing according to the
actual situation).
4. Tightly hold and release the brake handle several
times.
5. Loosen the drain bolt. When the brake handle has
an obvious pinching feeling, quickly tighten the
drain bolt to prevent brake fluid from flowing back
along the pipeline.
6. Release the brake handle.
7. Pour the brake fluid into the cup of the upper brake
pump.
8. Repeat the said Step 3-7 until the old fluid has
been completely replaced with the new fluid, and
the color of the fluid in the drain pipe is the same
as that of the new fluid in the cup of the upper
brake pump. When you feel the brake handle is
hard, and no bubbles are generated from the cup
of the upper brake pump cup, the drain bolt can be
tightened to complete the operation.
9. After the operation is completed, install the cover
of the upper brake pump, and check if the brake
works normally.
Recommended brake fluid: DOT 3 brake fluid
Caution
● Put on protection gears before
starting to work.
● The brake fluid corrodes the paint
on the motorcycle body, so please
take protection measures before
starting to work.
● Prevent the fluid from overflowing
from the cup when replacing the
brake fluid.
● Do not mix different types of brake
fluids.