Fellowes Standard Horizon SRN-9x, Service Manual

Page: 42 / 67

R O T A R Y
PAGE 40
S E R V I C E
Section 11 PLATEN
11.3..... Platen - Adjustment
Set the operator adjuster cam shaft to the position shown in Fig.
11.31, and tighten the lock.
Set the numbering head mounting collars towards the sides of the
machine and lay a piece of 80gsm/20lb paper over the platen on
each side.
Hold a numbering head loosely on the collar and, holding it firmly
seated to the base of the collar, check the contact with the paper
on each side of the machine.
If adjustment is required on either side, use the following
procedure-
Platen Adjustment .....................................................Fig 11.31
Decrease Pressure Increase Pressure
Eccentric
Fixing Bolts
Adjuster Plate
Platen Lock
Platen
Adjustment Cam
Edge of Principle
Bearing Housing
Operator Side Shown - See
Fig 11.11 for Clutch Side
Set Cam to 30 0