Fellowes Standard Horizon SRN-9x, Service Manual

Page: 33 / 67

N U M B E R E R
PAGE 31
M A N UAL
Section 9 CLUTCH ASSEMBLY
9.3B .... Over-travel - Adjustment (New Syle Clutch)
The over-travel adjustment on the new style clutch can be done without
removing the clutch from the machine as follows:- (See Fig 9.32).
1. Remove the clip from its groove.
2. Operate the actuator to release the control collar.
3. Slide the control collar at least 5mm outwards.
4. Slide the inner collar off the inner control ring.
5. Turn the inner control ring and the inner collar as indicated, until they stop and
re-engage both.
6. Check that the over-travel is minimised without the clutch binding. Re-adjust if
required.
7. Adjust control collar by sliding off of its splines, to obtain the stopping position
shown in Fig 9.21 on page 27; so that the machine prints accurately to scales
on collars.
8. Replace clip.
WARNING:
THE INTERNAL CLEARANCES WITHIN THE CLUTCH/
BRAKE UNIT ARE PRACTICALLY ZERO. ANY INGRESS
OF DIRT OR OTHER CONTAMINATES WILL SERIOUSLY
AFFECT THE PERFORMANCE OF THIS UNIT. EXTREME
CARE SHOULD BE TAKEN TO PROTECT ALL
COMPONENTS DURING DISMANTLING & RE-ASSEMBLY.
DO NOT USE LUBRICANTS