Fellowes Standard Horizon SRN-9x, Service Manual

Page: 25 / 67

N U M B E R E R
PAGE 23
M A N UAL
Section 7 INKING
Care should be taken to guide the circlip through the radial slot in
the sideframe. (The operator side support arm will slide off the tie
bar which will remain in the machine).
Remove the circlip and continue to draw the support arm and shaft
out of the machine from the operator side whilst sliding the transfer
rollers off the shaft.
Care should be taken not to damage the shaft on the side frame
slots, as this will cause the transfer rollers to jam on the shaft.
Re-assembly is a reverse of the above, but don't forget to replace
the circlip after re-installing the transfer rollers, as it retains the
shaft laterally between it's bearings.
If you experience any difficulty in sliding the shaft into the clutch
side bearing (which remained in it's support arm during
dismantling), use a 6mm cap head bolt & large washer to draw the
shaft into the bearing.
DO NOT USE A HAMMER.
7.2 ...... Adjustment - Transfer Roller Pressure
Remove the green polycord drive belt from the operator side.
Position one transfer roller near each of the two side-frames & set
a numbering collar below each transfer roller.
Set a numbering head loosely on a collar and, holding it firmly
seated to the base of the collar with your hand, adjust the inking
stop screw until a slight contact is made between the numbering
head and the transfer roller.
Repeat for the opposite side and double-check the adjustments as
adjusting one side may affect the opposite side.
Move the inking assembly to the secondary position (or primary
position - see operators guide for details), and repeat the steps
above.
Finally increase the pressure at each inking stop screw by 1½
turns (counter- clockwise, viewed from head end of screw).