5
Let our experts help you with a solution.
Customer Service...
www.fellowes.com
Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.
NEED HELP?
Switch the power on (located at the rear of the machine).
The control panel buttons will flash once as part of a check light system to ensure
proper function.
The machine defaults to the 3mil hot setting. For 4mil, 5mil or cold laminating
press the corresponding pouch selection buttons.
When the machine is ready, a beep will sound and temperature setting button will
stop flashing and remain on.
Place the document into the open pouch. Ensure the document is centered against
the sealed edge. Use the appropriate pouch size for the document.
Ensure the pouch enters the machine sealed edge first. Keep the pouch straight
and central within the slot, not on an angle. Use the entry markings as a guide.
Upon exit, the laminated pouch may be hot and soft. For the best quality and to
prevent jamming remove the pouch immediately. Place the pouch on to a flat
surface to cool. Take care when handling a hot pouch. Always remove laminate
pouch before starting next laminate.
To release a pouch during lamination activate the release lever located at the
rear of the machine. Gently pull pouch out of machine.
4.
5.
6.
7.
8.
9.
10.
11.
Ensure the machine is on a stable surface.
Check there is enough clear space (min 20”) behind the machine to allow items
to pass through freely.
Plug the machine into an easily accessible main socket.
1.
2.
3.
SETTING UP THE LAMINATOR
HOW TO LAMINATE
Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to
polish the machine. Cleaning sheets can be used with the machine. When the machine is warm – run the sheets through the machine to clean any residue off the rollers. For
optimum performance, it is recommended that cleaning sheets are used with the machine regularly. (Cleaning sheet order codes #5320603)
Problem
Possible cause
Solution
No control panel illumination
Machine not switched on
Switch on machine at rear next to plug inlet and at the wall socket
Lamination Feed Sensor LED is blinking
Laminate was mis-fed
Hold down the release lever and remove the item by hand
All LEDS are dimly blinking
Laminator has gone in to Auto Shut Off
mode
Press any button or cycle the power switch to re-start the machine
Pouch does not completely seal the item
Item may be too thick to laminate
Check pass through thickness is correctly selected and pass through again
Temperature setting may be incorrect
Check pouch thickness is correctly selected and pass through again
Pouch has waves or bubbles
Temperature setting may be incorrect
Check pouch thickness is correctly selected and pass through again
Pouch is lost in the machine
Pouch is jammed
Operate the release lever and pull out the item by hand
Jamming
Pouch was used ‘open end’ first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Pouch is damaged after lamination
Damaged rollers or adhesive on rollers
Pass cleaning sheets through the machine to test and clean rollers
TROUBLESHOOTING
STORAGE & CLEANING