background image

 
 

 
 
Federal Communication Commission Interference Statement 

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable 
protection against harmful interference in a residential installation.    This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications.  However, there is 
no guarantee that interference will not occur in a particular installation.    If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the interference by one of the 
following measures: 
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
- Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

- Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with part 15 of the FCC rules.    Operation is subject to the following two 
conditions. 
 
1)  This device may not cause harmful interference, and 

2)

  This device must accept any interference received, including interference that may cause 

undesired operation.

 

 
Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the 
part responsible for compliance could void the user’s authority to operate the equipment.

 

 
IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 
environment. End users must follow the specific operating instructions for satisfying RF 
exposure compliance. 

 

This transmitter must not be co-located or operating in conjunction with any other antenna or 
transmitter. 

 

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection 
facilities.  
 
Contact your local government for information regarding the collection systems available. 

 

If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into 
the groundwater and get into the food chain, damaging your health and well-being. 
 
When replacing old appliances with new once, the retailer is legally obligated to take back your 
old appliance for disposal at least for free of charge.

 

 

14 

Summary of Contents for SmartGuard E120CA-1









Reviews: