background image

To record your own alert sound/voice: 

 

z

 

Select audio warning 3 or 4.   

z

 Press 

Set

 for 3 seconds, the light flashes 

once implies the SmartGuard is ready for 
recording. 

z

 

Wait for 5 seconds, LCD occurs with 
REC, the recording starts. 

z

 

After that, LCD returns back to audio 
warning 3 or 4.  The recorded sound 
will be played for verification.   

 

Note:

 The recording time is 10 seconds.    If video is in the middle of recording, the 

setting of audio warning will not be available until video recording is finished.   
 
 
 

PIR Sensitivity 

 

 

Four levels of PIR sensitivities are available 
for selection to achieve an optimal 
performance of PIR detection. 
 

z

 

Under audio warning mode, press 

Set

 

once to enter PIR sensitivity 1 (preset 
mode). 

z

 

The light turns on indicating SmartGuard is ready for setting. 

z

 Press 

Up

 or 

Down

 to change PIR sensitivity. 

 

Note:

 PIR sensitivity 1 is the highest sensitivity level while PIR sensitivity 4 is the 

lowest sensitivity level. 
 
 

ID Code Learning (for remote 
controller only) 

 

 

This setting is equipped for remote controller.   
Please note the remote controller is sold 
separately. 
 
 
 
 
 

 

Adjusting the Control Knobs

 

 

 

Time Control 

 
The TIME adjustment controls the video recording time and 
amount of TIME light stays on after the motion is detected. 
 

z

 

Set the amount of TIME by sliding the knob to 20sec, 1 
or 5 minutes. 

 

Note:

 Light stays on time might be extended as long as a 

motion is detected. 

 

Lux Adjustment

 

 

The LUX adjustment determines at what light level the light starts 
operating. 
 

z

 

Set the LUX control knob to any position between sun 

 

(200LUX) and moon 

 (20LUX). 

z

 

Set scene mode to Scene 2 (refer to p.6 for scene setting). 

z

 

If ambient light falls below the set LUX level, the light will start operating. 

z

 

Adjust LUX control knob slightly until desired LUX level is found.   

 

 

 

Mounting SmartGuard

 

 

Safety Precautions

 

 

z

 

Do not install SmartGuard when it 
is raining.

 

z

 

Be sure to switch off power source 
before installing. 

z

 

When mounting on the wall, it can 
be installed only vertically, not 
horizontally. 

 

 

VERTICAL   HORIZONTAL 

 

Step 6 

Step 7 

Summary of Contents for SmartGuard E120CA-1









Reviews: