37
!
#
"
Edgebander
G 330 / G 360 / G 380
Inspecting and adjusting settings
Inspecting and adjusting settings
Note:
This unit is used to remove the protruding tape (at the outset and the end).
Once the tape has been cut flushly, the tip saw unit returns to its exit position.
!
Copying pad for front cut
"
Copying pad for rear cut
#
Socket head cap screw to adjust the copying pad
8.9 Setting the protruding edging - End trimming unit
Warning! Risk of injury!/Risk of material damage!
Handle the saw blades carefully to avoid injuring your hands and damaging the cutting edges.
Note:
Changing the saw blade - See chapter entitled: Maintenance/Service
The protruding edge is defined by the distance between
the feeler pad and the saw blade.
The protruding edging is usually set to 0 (factory setting).
It may be necessary to readjust the protruding edge
setting if the saw blade has been changed or replaced.
1.
Switch the machine off and ensure that it cannot be
switched on again. Open the rear access door.
2.
Feeler pad: Clean thoroughly.
3.
The pad is kept under tension by spring discs. If the
2 screws are screwed tighter, and the tension within
the pads increased, the edge will be cut shorter. If
the screws are loosened, then the edge cut will be
shallow (leaving more edge).
4.
Both adjusting screws need to be adjusted by the
same amount at the top and the bottom. If the
copying pad is not straight it can influence the final
results and/or damage the workpiece.
5.
Adjust other units or close the sawguard.
Note:
Proceed very cautiously with the settings described here. The given values are recommended values and
must be tested using sample workpieces.
Fig. 8-12: Adjusting the copier pads
