59
%
&
$
!
"
#
!
Edgebander
G 330 / G 360 / G 380
10.10 Replacing the buffing pads - Buffing unit
Fig. 10-20: Buffing unit
Fig. 10-21: Replacing the buffing pads
Respect the general safety rules.
See chapter entitled >10.1 Safety instructions<
Required tools:
• Spanner SW 13 mm
1.
Switch the machine off and ensure that it cannot be
switched on again. Open the rear access door.
2.
Retain the position of the buffing brushes with
markers.
Loosen the clamping screws, Pull out the motor
backwards and lay it on the working table.
3.
Loosen and remove the motor fixing screw.
Remove the flange and the brushes.
4.
Place new brushes onto the motor.
Screw on the flange and the screws.
5.
Mount the motor onto the fixture. Check the position
of the buffing brushes (markers).
Tighten the clamping screws.
6.
Repeat the procedure with the bottom unit.
Test the adjustment and if required, readjust.
See chapter entitled >Setting the buffing unit<
!
Marking
"
Clamping screws
#
Adjustable support
$
Fixing screw - Brush
%
Flange
&
Polishing wheel (Brush)
Attention! Risk of material damage!
Remove one set of buffers at a time to avoid putting the motors back in the wrong place.
The screw of the bottom buffer has a left-hand thread.
Maintenance/Service
