43
$
$
!
!
#
"
!
!
Edgebander
G 330 / G 360 / G 380
Inspecting and adjusting settings
Attention! Risk of material damage!
The unit or rather the knife should not be allowed to damage the workpiece, it serves to scrape the excess
glue from the workpiece. The knife has various settings depending on the quality of the workpiece, the
workpiece surface structure etc.
The glue scraper knife removes glue residues between
the edging material and the workpiece.
The settings for the depth of cut are defined by the two
follower rollers.
Activate / Deactivate:
Standard equipment: Manual adjustment
To disengage the lower and upper glue scrapers, pull
knob 4, thus moving the unit away from the workpiece.
Adjusting the depth of cut:
1.
Switch the machine off and ensure that it cannot be
switched on again.
Open the (large) right-hand side sawguard.
2.
Loosen the clamping screws.
Adjust the depth of cut using the adjusting knobs.
Anti-clockwise:
Deeper cut
Clockwise:
Shallower cut
Note: Always adjust towards the workpiece to
compensate for the thread backlash.
3.
Tighten the clamping screw.
4.
Check the adjustment and repeat if required.
Attention! Risk of material damage!
1) This setting has to be exact.
2) Only use this unit on PVC edging!
The scraping knives and/or the workpieces may be damaged if the setting is incorrect or if material
other than PVC is used.
!
Adjusting knob - Chip thickness
"
Clamping screw
#
Follower rollers
$
Knob to exclude scraper
8.11.2 Flush scraping unit (Optional)
Fig. 8-18: Glue scraping unit
