15
CRH Arrotondatore per spigoli diritti e sagomati
Ed. 08/2005 Pag. 14
ITA
FRA
D
CRH Arrondisseur copieur hydropneumatique
Ed. 08/2005 Pag. 14
CRH Hydropneumatischer Eckenkopierer
Ed. 08/2005 Pag. 14
fig. 2.3.1
A
B
C
D
F
E
Corner rounding machine
ERM 1050
5.4 Compressed air supply connection
The filter/pressure regulator with outflow of condensation
and a lubricator together with quick fitting are located
on the right-hand side of the machine. The fitting is for
10 mm ext. diameter pneumatic hoses (Type RISLAN).
Ensure that the compressed air reaches the connecting
area at least 7–8 bars and that the pressure is free from
humidity and has been suitably filtered.
The length and the inside diameter of the pneumatic
hoses must be proportioned for a correct functioning of
the CRM.
Adjust the air pressure to 6.5 bars.
The machine is adjusted and tested with this pressure.
Minimal power of the compressor: 3 HP
Note: Before proceeding to any maintenance operation, it is necessary to disconnect the
compressed air system.
Attention!
NEVER supply the CRM using a pneumatic
hose with an internal diameter measuring
less than 4 mm.
Attention!
Never add lubricant oils in the condensation collecting cup C.
Fill up periodically the oil cup D fig. 2.3.1 with the
following kind of oil: -SAE #10
Adjust the lubricator F at 2 drops per minute. To outflow
the condensation it is sufficient to push upwards the tap
C with the filter/regulator under pressure.
Installation
