9
Corner rounding machine
ERM 1050
2.8 Machine hazards
The machine has undergone a hazard analysis. The
design and construction of the machine are based on the
results of this analysis and correspond to state-of-the-art
technology.
The machine is considered operationally safe when used
properly.
Nevertheless, there are some remaining risks that must be
considered.
The machine runs with high electrical voltage.
2.9 Other risks
•
Before carrying out any maintenance, cleaning and
repair work, switch off the machine and ensure that it
can not be accidentally switched on again.
•
When carrying out any work on the electrical equip-
ment, ensure that the voltage supply is completely
isolated.
•
Do not remove any safety devices or alter them to
prevent them from functioning correctly.
Safety
Warning! Danger! Electric current!
Electrical energy can cause serious bodily injury. Damaged insulation materials or defective individual
components can cause a life-threatening electrical shock.
Only on machines with spindle moulder unit:
• Danger of injury due to contact with the rotating moulder tool.
•
Risk of injury from ejected tool pieces (e.g. cutting pieces).
• Therefore never stand directly within sight of the machining units when the machine is operating (whether the
machine is working or on stand-by mode)!
General safety rules:
•
Be wary of sharp edges to avoid cutting yourself, in particular when changing the tooling.
•
Risk of injury due to ejected work pieces and parts of work pieces (e.g. branches, chips).
•
Risk of injury from workpiece kickback.
•
Hearing damage as a result of high noise levels.
•
Risk of damage to health from dust especially when working hard woods.
• Risk of injury through being crushed, cut, caught, wound up or sliced.
Warning! Risk of injury!
Even if the safety measures are complied with, there are still certain associated risks that must be considered
when working on the machine:
