14
Corner rounding machine
ERM 1050
5. Installation
5.1 Lifting and transport
5.2 Array of the machine
5.3 Dust extraction port
Preferably use a fork lift or transpallet to handle transport
of machine, since its frame allows their use.
The machine is delivered with a thermal shrinked nylon
protection or carton.
Locate the machine in a suitable place, considering the
dimensions of the machine, space needed for stacking,
loading and offloading workpieces, leaving sufficient
space for the operator to move freely.
Connect to an efficient dust extraction system to the two
flexible hoses Ø 100 mm, situated at the rear of the
machine.
To avoid any accidents during transport make sure that
the machine is firmly secured to the forklift with ropes or
other suitable systems.
Note: Make sure, by using a water level or any other equivalent good quality level, that the
working table is levelled in both directions. Tolerance ± 0,25 mm in longitudinal direction.
Note: When working with machine with flush trimming in function, the dust extraction system
must be in use.
The machine base must be layed on a even solid surface.
For a correct functioning it is necessary that the air speed
of the dust outlets is not below 20 m/min.
Installation
