Step-by-Step Assembly:
Page 8
Eyepiece Assembly:
Remove the cover from the eyetube (1). Insert the
eyepiece into the eyetube.
Match up the positioning screw (2) into the eyetube
groove (3) when inserting the eyepiece into the
eyetube.
Power Cord Connection:
Set the main switch to “O” (off) position.
Connect the lower light source plug (1) into the
socket (2) on the back of the microscope.
Insert one end of the power cord (3) into the power
socket (4). Plug in the microscope.
Use only the power cord supplied by Fein Optic.
Illumination:
Turn the main power switch to “--” on.
Adjust the light rheostat control (4) until the
illumination is comfortable for observation. Rotate
the light rheostat knob clockwise to raise the voltage
and brightness. Rotate counterclockwise to lower
the voltage and brightness.
Press the light intensity reset button (1) to reset the
light intensity to the preset position. Rotate the set
screw (2) with a small flathead screwdriver to set the
light intensity. Rotating it clockwise will raise the
light intensity, counterclockwise will lower it.
Voltage indicator (3) shows voltage intensity.
Using bulbs in low voltage state will extend bulb life.
The rheostat knob will not work when the light
intensity button is pressed.
Microscope light intensity is pre-set to the best light
for photomicrography with a daylight-balanced
(LBD) filter.
