Step-by-Step Assembly:
Page 6
Light Source Assembly & Bulb Replacement:
Loosen the lock screw (1) completely with an M4
spanner and remove the cover.
Open the bulb lock (2).
Handle the bulb (3) with a clean glove or soft tissue
(do not touch the bulb with fingers).
Insert the bulb pins (4) into the bulb holder (5).
The bulb should be vertical after assembly.
If any fingerprints got on bulb, wipe clean with a
clean, soft cloth.
Replace bulb only with 12v, 100w halogen bulb
(part# 12v100wH).
Before replacing the bulb, make sure to unplug and
power off the microscope. Wait for the bulb housing
to cool off before opening.
Light Source Microscope Assembly:
Push the light source holder (1) into the body of the
microscope. Keep the light source horizontal in
relation to the microscope body and tighten the
screw (2).
Stage Assembly:
Loosen the set screw (1) on the stage.
Center the stage on the base, aligning the two “V”
notches on the bottom of stage and on the
condenser (2).
Tighten the set screw.
