OBID
®
System-Manual
ID RW40.30-USB
FEIG ELECTRONIC GmbH
Page 52 of 57
H80701-2e-ID-B.doc
Hex-value
Parameter Status
0x10
EEPROM-failure:
•
the EEPROM of the reader is not able to be written on
•
before writing onto the EEPROM a faulty checksum of parameters has been detected
0x11
Parameter-Range-Error:
the value range of the parameters was exceeded
0x12
Password-Cycle-Error:
•
new password has been sent to the reader before the old one
•
new password has not been sent to the reader within 2 s after the old one
0x13
Login-Request
Configuration- or data protocol, without login to the reader
0x14
Login-Error
Wrong login password
Hex-value
Password Status
0x6n
Password-failure
0:
general fault while storing a password
1...9:
n-th password is not stored in the protocol "transponder password"
•
old password is not correct
•
the EEPROM of the reader / cryptocontroller cannot be written on
Hex-value
Interface Status
0x80
Unknown Command
•
reader does not support the selected function
•
storing a password in the reader for a transponder that is not supported by the
software
0x81
Length-Error:
Protocol is too short or too long
0x82
Command not available:
The sent command is not available at the moment
•
Polling access while Auto-Answer-Mode is active
0x83
Com-Error RF Module - ID RW24
The serial communication between the RF-module and the ID RW24 is disturbed or not
possible