Feig Electronic ID ISC.ANT600-DA, Application Note

Page: 23 / 26

OBID i-scan
®
Application-Note ID ISC.ANT800/600-DA
FEIG ELECTRONIC GmbH Seite 23 von 26 N50101-0e-ID-B.doc
4.3. Testing the Performance
For this performance test we will be assuming the conditions described in the section 1.1. Project
Notes . The indicated ranges and read areas will change correspondingly when different labels are
used. For testing the ISO Inventory function has to be activated like in 4.2. Reading out a Serial
Number .
For the different label orientations you have to use different test methods, which are described
below:
4.3.1. Testing parallel Label Orientation
Begin the test by checking the read range outside the gate (see Figure 10, position
d
), assuming
the configuration and local conditions permit. Assuming a parallel label orientation with respect to
the antenna facing out, a read range at the centre of the antenna should be 60-65 cm. This test
should be repeated for both antennas. The read range may vary here by a few centimeters (ap-
prox.
±
2.5 cm).
Now slowly move the label vertically and horizontal in the gate as shown in Figure 10. The label
should always be read.
Figure 10: Performance Test with parallel Label Orientation