Series ’90 Hot Deli
Page
6
DANGER:
Electrical shock hazard. Do not operate unit with
panels removed.
Grill Removal
The front of the case has a removable panel base to access the front leg levelers from inside the case.
Normally it is not necessary to remove the panel to install the case. The panel must be in place for proper
operation of the case.
The rear of the case has a removable base panel to allow access to the field wiring connection box. Remove
the panel to make field wiring connections. The panel must be in place for proper operation of the case.
Plumbing Connections
The case is supplied with a 1/2” female NPT pipe coupling and a 1” male NPT drain fitting that can be used
for a connection to a water source and drain. A pan filler spray hose is also provided. This spray hose has a
1/2" male NPT fitting for connection to a water supply. If the case is hooked to a water source, it is advisable
to install a shut-off valve in the water supply line.
Plumbing connections do not have to be made up in order for the case to operate properly. The well(s) can
be manually filled to the correct level and they can be drained with the use of a catch container.
Display Component Check
The case is supplied with incandescent lighting. The lights are mounted on the ceiling of the case. The
control switch for the lights is located on the control panel on the back of the case. The lights should be
turned off any time the case is not in operation.
The case is also equipped with a top mounted full-length infrared heater. The heater temperature control is
on the control panel on the back of the case. The temperature control knob has an “off” position and
numbered positions from 1 to 7 depending on the amount of heating required. There is a pilot indicator
above the temperature control knob that lights when the knob is moved to a numbered position. After the
case is properly wired to the power source, the temperature control knob should be moved to a numbered
position to verify that the heater functions properly. The pilot light indicator will remain lit until the heater
reaches the proper temperature. The heater temperature control knob should be in the “off” position any
time the case is not in operation.
The case has separate temperature controls for each well in the control panel. The temperature control
knobs have an “off” position and numbered positions from 1 to 10 depending upon the amount of heating
required for each well. There is a pilot light indicator next to each temperature control knob that lights
when the knob is moved to a numbered position. After the case is properly wired to the power source, each
temperature control knob should be moved to a numbered position to verify each well is heating. This check
should be performed on one well at a time. The pilot light indicator will remain lit until the well reaches
proper temperature. The temperature control knobs should be in the “off” position when the case is not in
use.
The case is provided with an air circulation fan to prevent condensation from forming on the front glass
when water is used in the food wells. A switch is provided for the fan and is located on the control panel.
Cleaning
The case should be cleaned thoroughly before initial use.
For initial setup, clean the case as outlined in the cleaning section.
