- 35 -
SHELVING INSTALLATION & REMOVAL
Shelf Bracket & Supports
NOTE: Different shelf sizes and quantities are optional from factory so shelf bracket quantity and size may
vary, but procedure is the same.
1.
Turn the light switch to the off position. Remove rear doors as described in the “Rear Door Removal”
section of this manual to allow access to interior of case.
2.
Follow the instruction in the illustration below. Starting with the longest brackets for bottom shelf insert
(1) of the (2) shelf brackets in the desired shelf standard slot on one side of the case. Place the long
second shelf bracket in the same shelf standard slot on the opposite end of case. Important; The bracket
with the ½ hole must be on the light cord side of case.
3.
Repeat procedure for middle shelf brackets and the shortest top brackets. NOTE: Different shelf sizes
and quantities are optional from factory so shelf bracket quantity and size may vary, but procedure is
the same.
1.
Tilt shelf bracket upward and install shelf bracket hook into desired slot.
2.
Lift shelf bracket hook up behind back of shelf standard and rotate the shelf bracket
downward until desired shelf bracket tab rests on front of shelf standard.
3.
Bracket can be either flat 0 degrees 5 degree downward tilt as shown.
Summary of Contents for ITR Series
