22
Informer Wall Mount Series
Obtaining Service
MERGEFORMAT
Configuring
the
Informer-IPFORMAT
General
Description
ations
You can toggle the switch by moving it left for OFF or right for ON. The switch is on
when it is pushed away from the center of the Informer TAR. After the battery switch
is turned on, re-connect the Informer TAR to power. To verify the battery switch is
on, remove power from the Informer TAR and verify that the power LED begins to
flash. If the LED does not flash, check the battery switch position again and retry this
test.
Obtaining Service
Informer Wall Mount Service
Refer to the
Programming and Radio Alignment Manual for option I-SW
for
alignment instructions. Refer to an authorized Federal Signal Service center for radio
alignment and servicing.
If you are experiencing any difficulties, contact Federal Signal Customer Care at:
800-548-7229 or 708-534-3400 extension 5822 or Technical Support at:
800-524-3021 or 708-534-3400 extension 7329 or through e-mail at:
[email protected]. For instruction manuals and information on
related products, visit: http://www.alertnotification.com/
Replacing the Battery
The Informer uses a 6 V, 1.2 A/H sealed valve regulated rechargeable battery (part
number 155191A). Replace the battery with the same make and model battery as the
original equipment. Typical battery life ranges from three to five years depending on
use.
The battery is located between the Informer door and PC board, and should only be
replaced by a qualified service technician.
Batteries installed shall not be exposed to excessive heat such as
sunshine, fire or the like.
Summary of Contents for Informer I-HIOW
Page 29: ......
