Informer Wall Mount Series
11
Installation Instructions
Wall Mounting
Wall mounting is the preferred mounting method for the Informer. Before mounting
the unit, determine a suitable location considering the criteria listed previously. The
Informer has eight holes, two sets of four, located on the back of the unit that accepts
#8 screws. Mounting location determines which set of four holes are used. Exterior
wiring can enter the Informer through any of the unit’s five knockouts: two on back,
one on the bottom, and one on each side of the unit. Place the mounting screws
horizontally level, approximately six (6) inches above eye level and four (4) inches
apart on center. Ensure the screws are placed into material that can adequately
support the weight of the Informer. Use #8 wall anchors when mounting to drywall.
Ensure that the screws are tightened sufficiently to securely fasten the Informer
against the wall.
Figure 1 Rear View
– Hole Measurements
Mount the local rubber antenna vertically on the front of the Informer so that the
antenna is pointed toward the ceiling. If you require an external antenna, have it
installed by a qualified electrician in accordance with local and national electrical
codes.
Summary of Contents for Informer I-HIOW
Page 29: ......
