12
Informer Wall Mount Series
Installation Instructions
MERGEFORMAT
Configuring
the
Informer-IPFORMAT
General
Description
ations
Recessed Mounting
Before mounting the Informer, determine a suitable location considering the criteria
listed in the “Determine a Suitable Location” section. The Informer has four holes for
recessed mounting, two sets of two, located on the sides of the unit that accepts #10
screws. Mounting location determines which set of holes are used. Exterior wiring
can enter the Informer through any of the unit’s five knockouts: two on the back, one
on the bottom, and one on each side of the unit. Place the mounting screws
horizontally level, approximately six (6) inches above eye level and four (4) inches
apart on center. Ensure the screws are placed into material that can adequately
support the weight of the Informer. Use #8 wall anchors when mounting to drywall.
Ensure that the screws are tightened sufficiently to securely fasten the Informer
against the wall.
Figure 2 Side View
– Hole Measurements
1. Cut a hole that is 8.25 inches x 7.25 inches x 3 inches (H x W x D), which is
slightly larger than the Informer-IP base and next to a wall stud.
2. Attach the face bracket to the sides of the unit using the four 10-32 screws
included.
3. Slide the Informer into the wall and from the inside of the unit mark the side hole
locations on the wall stud.
4. Remove the unit and drill the two holes for #10 screws.
5. Place the mounting screws horizontally level.
Summary of Contents for Informer I-HIOW
Page 29: ......
