Lo Cmp sub-menu [1/2]
– from this page it is possible to set the Threshold and Ratio
parameters of the RMS Low Compressor.
Note
: The RMS Low Compressor Threshold is defined in dBu, due to the fact that with both,
Sinusoid and Squared wave testing signals, the DLM26 compressed output dBu (RMS) Level is the
same and matching the selected one.
Lo Cmp sub-menu [2/2]
– from this page it is possible to set the Attack Time. Release Time
and “Knee” type of the RMS Lo Compressor.
Lo Limiter sub-menu
– from this page it is possible to set the Peak Low Limiter.
Note
: The Peak Low limiter Threshold is defined in Vp, due to the fact that with both, Sinusoid
and Squared wave testing signals, the DLM26 Peak Low Limited output Vp (Peak-Peak) Level is
the same and matching the selected one.
Note1
: once the desired options have been selected using the 3 encoders, they are automatically
saved as current and stored in the DLM26 system status once leaving the page.
Note2
: to exit this page, push the “ESC” button.
Lo Gain page
– from this screen it is possible to set the Output Level of the Rms Low Compressor
+ Peak Low Limiter cascade from -12dB to +6dB, press ENTER an arrow will appear on the left of
the screen “
->
” then use the “Param.2” or “Param.3” buttons.
The value set on this screen will only affect the output level of the selected Rms Low Compressor
+ Peak Low Limiter cascade.
The following is an example screen for the “Lo Gain” page where the Lo Gain is set to +0.0dB
Lo Phase page
– from this page it is possible to set the Output Polarity of the Rms Low
Comp Peak Low Limiter cascade, by using the “Param.2” or “Param.3” encoders.
The polarity can be “Normal” or “Inverted” (which means rotated of 180 Degrees).
The following is an example of a “Lo Phase” screen where the Polarity of Output Channel 1 is set
to “Normal”
Out-1 Name Lo Phase
-> Polarity = Normal
Out-1 Name Lo Gain
-> Gain = + 0.0dB
Summary of Contents for DLM26
Page 66: ......
