4+1 DCL
.........
in this operating mode, the DLM26 is performing a 2 Input to 5 Outputs X-
Over configuration, where 1 of the available Outputs (Ch1) is “Full Band” Mono output but
performing a 2 bands Rms Compressor and Peak Limiter, where the splitting frequency of the 2
bands can be custom selected.
The Outputs of the Channels 3/4/5/6 are performing as in Standard Mode:
−
Outputs 1 [5 Bands Eq +2Bands Rms Comp 2 bands Peak Limiter]
−
Outputs 3/4/5/6 [ 5 Bands Eq +Rms Comp Peak Limiter]
−
Outputs 2 [Muted]
When the “3 DCL” is selected, the “System Setup” page will appear as follows:
To change the desired operating mode for the DLM26, the screen must reflect the mode
required and then simply pressing the “ENTER” button will bring up the following screen asking
for confirmation to load the selected operating mode:
If confirmed by pressing ENTER the selected preset mode will load. While the device is
configuring the Xover the following screen will be appear:
The new preset mode will now be shown with an asterisk.
New Xover
[ENTER] to confirm
Please Wait .....
Changing Xover
System Setup
Setup: 3 DCL
*
Summary of Contents for DLM26
Page 66: ......
