Fbt DLM26, User Manual

Page: 12 / 66

To change the desired operating mode for the DLM26, the screen must reflect the Mode
required and then simply pressing the “ENTER” button will bring up the following screen asking
for confirmation to load the selected operating mode:
If confirmed by pressing ENTER the selected mode will load. While the device is configuring
the Xover for the chosen Mode, the following screen will be appear:
The new operative Mode will now be shown with an asterisk.
−
System Setup: this page allows the selection of the operating setup of the DLM26:
Entering this page, will allow to chose between 3 available operative Modes (if previously
selected the “Custom” option within the System mode Page, or 3 available operating Setups.
If selected the “ Standard Mode ” within the System Mode page, the operating Setup can be
chosen from a selection of 3 X-overs options:
2x2 WAY + SUB ........... in this setup, the DLM26 is performing a 2 Input to 4 Outputs X-
Over, plus a SUB configuration, where the 2 Inputs are automatically assigned to the Outputs
as follows:
−
Input A to Outputs 1/3 [Out1=Low-A and Out3=High-A]
−
Input B to Outputs 2/4 [Out2=Low-B and Out4=High-B]
−
Input A + Input B to Outputs 5/6 [Out5=Sub-A and Out6=Sub-B]
2x3 WAY .. XOVER ......... in this setup, the DLM26 is performing a 2 Input to 6 Outputs X-
Over, where the 2 Inputs are automatically assigned to the Outputs as follows:
−
Input A to Outputs 1/3/5 [Out1=Low-A , Out3=Mid-A and Out5=High-A]
−
Input B to Outputs 2/4/6 [Out2=Low-B , Out4=Mid-B and Out6=High-B]
6 WAY .. XOVER ....... in this setup, the DLM26 is performing a Mono Input to 6 Outputs X-
Over, where the Input A is automatically assigned to the Outputs as follow:
−
Input A to Outputs 1/2/3/4/5/6 [Out1=Near-1, Out2=Near-2, Out3=Mid-1 and Out4=Mid-
2, Out5=Far-1, Out6=Far-2]
By pressing ENTER on the System Setup page and rotating the “Param.2” or “Param.3”
encoder, it is possible to select all the available X-Over preset setups.
SYSTEM UTILITY
-- System Setup --
New Mode
[ENTER] to confirm
Please Wait .....
Changing Mode