Delay page
– from this page it is possible to set the Output Channels Delay Time from
000.0000mS up to 848.9984mS, by steps of 1mS or 20.8uS.
To set the Delay time press ENTER an arrow will appear on the left of the screen “
->
”. then use
the “Param.2” encoder to set the Delay Time in steps of 1mS and the “Param.3”, for setting the
“fine” Delay Time in steps of 20.8 microseconds.
The following is an example screen for the “Delay” page where the Delay Time of Output Channel
1 is set to 160.1872mS:
“EVEN” Channel Editable Parameters
X-Over F page
– from this screen it is possible to set the X-Over Splitting Frequency, creating
the Low and High Bands where the RMS 2 bands compressor and Peak Limiters will operate.
On the Low Band will operate the “Lo Cmp” and “Lo Lim”, on the higher one, instead will operate
the “Hi Cmp” and Hi Lim”.
The following is an example screen for the “X-Over” page where the Splitting Frequency is set to
400Hz
Rotating the Param. 2 or Param. 3 encoders, the frequency can be modified by steps of 1Hz.
When in the Parameter's Editing Page, pushing once more the ENTER Button, it is possible to
access the page of the
Frequency Fast Setting
:
Here, the NAV/Param.1” encoder will increment/decrement the Frequency value by step of one
thousand Hz, the Param.2 by steps of one hundred Hz and the Param.3 by steps of one Hz.
Out-1 Name Delay
-> Delay = 160.1872mS
Out-1 Name X-Over F
-> Split Band F = 400Hz
Out-1 Name EQ-1
->Edit Freq = 1000Hz
Summary of Contents for DLM26
Page 66: ......
