6–1
S E C T I O N 6
Installer Functions
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
Keypad Programming
♦
Time Date Setup
♦
Walk Test
♦
Walk Test With Bell Output
♦
Default Reset
♦
System Log View
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
The control panel contains functions reserved for the installer to be used during the initial
installation and subsequent troubleshooting of the panel. Entry into the installer mode is
protected by a six-digit installer code that can be programmed for each installing company.
The default value for the installer code is 123456.
Entry into the installer mode requires the following sequence:
CODE
✴
[INSTALLER CODE] x
where:
CODE
is the CODE key on the keypad
✴
is the asterisk key
[INSTALLER CODE]
is the six-digit installer code
x
is the desired function as follows:
1 Keypad Programming
✴
2 Time/Day Setup
3 Walk Test
✴
4 Walk Test with Bell Output
✴
5 Default Reset
6 System Log View
✴
✴
LCD Keypad Only
The system must be in a disarmed state in order to perform any of the installer functions.
Keypad Programming
Keypad programming can only be performed through a LCD keypad. If the installed system
does not include any LCD keypads then a LCD keypad can be connected temporarily for
programming purposes. Alternately programming can be performed remotely through the
EZ-MATE Downloader. For information regarding keypad programming consult the LCD
Keypad Programming Guide.
Time Date Setup
This function allows the installer to modify the system date and time without use of a user
code.
