Xl-4, XL-4B, and XL-5 Hookup and Installation Instructions
Version 4
3–14
XK-5LC and XK-516 Surface Mounting
1- Remove the front of the keypad from the keypad
back by placing a straight-slot screwdriver into one
of the two slots in the bottom of the keypad and
twisting the screwdriver.
2- Select the desired keypad mounting location and
place the plastic rear plate of the keypad on the
wall. Mark the location of the cutout for the keypad
wiring cable.
3- Create an opening for the keypad wiring in the
location previously marked. Run the keypad wiring
using the four-wire connector provided to the
control panel.
4- Place the keypad wiring through the cutout
provided and secure the keypad backplate to the
wall through the holes provided (see diagram).
5- Connect the keypad wiring connector to the
keypad and place the keypad on the mounting plate
attached to the wall.
6- Snap the keypad front onto the the keypad back.
XK-7LC and XK-716 Surface Mounting
1- Select the desired keypad mounting location and
place the plastic rear plate of the keypad on the
wall. Mark the location of the cutout for the keypad
wiring cable.
2- Create an opening for the keypad wiring in the
location previously marked. Run the keypad wiring
using the four-wire connector provided to the
control panel.
3- Place the keypad wiring through the cutout
provided and secure the keypad backplate to the
wall through the holes provided (see diagram).
4- Connect the keypad wiring connector to the
keypad and place the keypad on the mounting plate
attached to the wall.
5- Secure the keypad to the rear mounting plate by
attaching the 5/8-inch screw provided in the lower
hole, located behind the keypad door.
OFF
1 2 3 4
