Xl-4, XL-4B, and XL-5 Hookup and Installation Instructions
Version 4
5–4
11) EMERGENCY KEYS
These keys generate Fire, Medical, or Panic signals when certain key combinations are
entered.
Sample LCD Display
The LCD keypad consists of a two line by sixteen-character display as shown in the sample
below:
BURGLARY ZN 055
MASTER BEDROOM
This sample display indicates that a burglary has taken place in zone 055, which corresponds
in the example shown above to the master bedroom.
Keypad Function Keys
Throughout this section of the manual the following conventions will be used to describe the
keystroke actions performed from the keypads.
BYPASS
Function key labeled BYPASS
INSTANT
Function key labeled INSTANT
STAY
Function key labeled STAY
CODE
Function key labeled CODE
✴
Key labeled
✴
within numerical section of keypad.
#
Key labeled # within numerical section of keypad.
[USER]
Four digit user code. These codes must already be
programmed into the system and represent the valid users
of the panel. User codes can be entered into the system
through an external programming device, through an
installer keypad programming session, or by an authorized
user through the keypad.
Note: From an initial default state the panel will contain
the user code 1234. Either the installer or end user must
program all other user codes.
Note: An option exists within the programming sequence to
select a 7-digit user code. If a seven digit user code is
selected then the user code will be the three digit user
number followed by the four digit user code (example user
number 43 with a user code of 7543 will be 0437543)
+
Indicates the simultaneous entry of two keys. For example,
✴
+ 3 means that the
✴
and 3 keys should be pressed at the
same time.
[Installer Code]
Six-digit code required to gain access to the installer mode
functions. This value can be modified through keypad
programming or the external programming devices. The
default value for the installer code is 123456.
Arming The System
System arming can be performed only if the system is ready.
System Ready
Under normal disarmed conditions the following message will appear in the display area of
the LCD keypad:
SYSTEM READY . . .
Note: The second line can contain a partition description that describes the location of the
alarm system (example, SMITH RESIDENCE). In addition the second line can scroll through
