SAFETY
Electrical
This dispenser must be properly electrically grounded to avoid possible fatal electrical shock or serious injury to
the operator. The power cord is provided with a three prong grounded plug. If a three-hole grounded electrical
outlet is not available, use an approved method to ground the dispenser. Only qualified electricians should
perform this task and the work performed should meet all applicable codes.
Always disconnect electrical power to the dispenser to prevent personal injury before attempting any internal
maintenance. Only qualified personnel should service internal components of electrical wiring.
Carbon Dioxide (CO2)
Strict attention must be observed in the prevention of CO2 gas leaks in the entire CO2 and soft drink system.
If a CO2 gas leak is suspected, immediately ventilate the contaminated area before attempting to repair the
leak. Personnel exposed to high concentrations of CO2 gas will experience tremors which are followed rapidly
by loss of consciousness and suffocation.
To avoid personal injury and/or property damage, always secure CO2 cylinders in an upright position with a
safety chain. Should the valve become accidentally damaged or broken off, a CO2 cylinder can cause serious
personal injury.
General Precautions
This equipment, depending on the model, weighs up to 460 pounds. To avoid personal injury or damage, do
not attempt to lift the dispenser without help. The use of a mechanical lift is highly recommended. Because the
dispenser is top heavy be sure to maintain in a vertical, upright position when lifting and positioning.
LEGAL
This Manual is for general informational purposes only and is not intended to cover every potential installation
or operational possibility. The parts and equipment addressed herein are warranted only to the extent covered
by FBD’s Parts and Equipment Warranty. FBD makes no express warranties as to any matter whatsoever and
hereby disclaims all implied warranties including, without limitation, the implied warranties of merchantability
and fitness for any particular purpose. In no event shall FBD be liable or obligated to customer or to any third
party for incidental, consequential, or special damages, regardless of the theory of liability, arising out of, or in
any manner related to FBD parts, equipment or any delay with respect to its delivery
4
This document contains proprietary information which is protected by copyright. All rights reserved.
© 2013 FBD Partnership, L.P. All Rights Reserved
The information contained in this document is subject to change without notice.
Summary of Contents for 77 Series
Page 1: ...772 773 774 24 2396 0001 Rev C 07 30 2013...
Page 38: ...38 772 Mounting Dimensions 773 Mounting Dimensions...
Page 40: ...40 WIRING SCHEMATIC DIAGRAM...
Page 41: ...41...