Freigabeversion
Original instructions | US-English
47
If the distance between speed sensor and spoke magnet is outside the
specified range or the speed sensor is not correctly connected, the
drive system operates in “Soft Fault” fault mode.
You can find detailed information here
→
in Chapter 23.1 “Status indicator”.
NOTE
Risk of damage!
If the spoke magnet and speed sensor are too close to each other and
touch each other, the two parts may be damaged and may have to be
replaced.
►
The spoke magnet must be positioned on the spoke so that it can
move freely past the speed sensor at the marking level.
19.2 Correcting incorrect position/alignment
If you notice that the drive system is in “Soft Fault” mode because the speed
sensor
[B.2]
and spoke magnet
[B.4]
are not correctly aligned, proceed as follows:
1. Carefully loosen the fastening screw
[B.5]
on the spoke magnet using a
screwdriver.
2. To set the correct distance between the mark
[B.3]
on the speed sensor and
the spoke magnet
[B.4]
:
• Move the spoke magnet vertically on its spoke (up/down), if necessary.
• Turn the spoke magnet around its own axis if necessary.
B.5
B.5
B.4
B.4
3. If the problem cannot be solved, do not use the e-bike but contact an
authorized specialist to have the fault rectified.
