Fayat Group Dynapac CC900G, Instruction Manual

Page: 99 / 104

Maintenance - 2000h
4812163901_A.pdf 2019-09-23
Hydraulic fluid filter - Change
Fig. Engine compartment, left side
1. Hydraulic fluid filter
1
Remove the filter (1) and deliver to special waste
handling. This is a single-use filter and cannot be
cleaned. Remove the filter (1) and deliver to special waste
handling. This is a single-use filter and cannot be
cleaned.
Thoroughly clean the filter holder sealing surface.
Apply a thin coat of fresh hydraulic fluid to the rubber
gasket on the new filter.
Screw the filter on by hand, firstly until the filter gasket
makes contact with the filter base. Then rotate a
further ½ turn.
Do not over-tighten. The seal can be damaged. Do not over-tighten. The seal can be damaged.
Start the engine and check that the filter does not leak.
Engine oil and oil filter - Change
Fig. Engine compartment, left side
1. Drain hose
2. Plug
3. Oil filter
1,
2
3
2
Run the engine until it is warm before draining the oil.
Switch off the engine and push in the
reserve/parking brake knob. Switch off the engine and push in the
reserve/parking brake knob.
Take great care when draining fluids and oils.
Wear protective gloves and goggles. Take great care when draining fluids and oils.
Wear protective gloves and goggles.
Place a receptacle that holds at least 4 liters (1 gal.)
under the drain plug (2).
91