Fayat Group Dynapac CC900G, Instruction Manual

Page: 52 / 104

Miscellaneous
4812163901_A.pdf 2019-09-23
1
2
3
4
Fig. ROPS locking device
1. Tensioning screw
2. Pin
3. Stud
4. Rubber buffer
To retract the ROPS, release the tensioning screw (1),
and pull out the pin (2) and stud (3). Do the same on
both sides. Lower the ROPS backwards if there is
space.
Remember to dismantle the rotating warning light
before lowering the ROPS. Remember to dismantle the rotating warning light
before lowering the ROPS.
After lowering the ROPS, replace the pin and stud. After lowering the ROPS, replace the pin and stud.
To lift the ROPS proceed in the reserve order.
Always make sure the ROPS is locked in raised
position before operation. Always make sure the ROPS is locked in raised
position before operation.
Grease the tensioning screw (1) and stud (3)
periodically.
Towing
The roller can be moved up to 300 meters (1,000 ft)
using the instructions below.
1
Fig. Drum
1. Propulsion motor, located left
front and right rear.
Switch off the gasoline engine and push in the
emergency stop knob. Chock the drum to prevent
the roller from moving when the brakes are
disengaged. Switch off the gasoline engine and push in the
emergency stop knob. Chock the drum to prevent
the roller from moving when the brakes are
disengaged.
The brakes in each propulsion motor must be
mechanically released, as described below,
before the roller is towed. The brakes in each propulsion motor must be
mechanically released, as described below,
before the roller is towed.
44