Fayat Group DYNAPAC CC224C, Instruction Manual

Page: 97 / 168

Miscellaneous
4812159701_D.pdf 2021-03-16
Short distance towing when the engine is
inoperative.
1
2
3
Fig. Brake disengagement valve
1. Valve
2. Pump arm
3. Knob
Chock the drums to prevent the roller from moving
when the brakes are hydraulically disengaged. Chock the drums to prevent the roller from moving
when the brakes are hydraulically disengaged.
Open both towing valves as described earlier.
The brake disengagement pump is located behind the
left door of the engine compartment.
Make sure that the valve (1) is closed, this is done by
tightening clockwise with the knob (3). Pump with the
pump arm (2) until the brakes are disengaged.
Ensure that the valve is reset into open position after
finished towing. This is done by turning the knob
counter clockwise to full extracted position.
Towing the roller
When towing/recovering, the roller must be braked
by the towing vehicle. A towing bar must be used
as the roller has no brakes. When towing/recovering, the roller must be braked
by the towing vehicle. A towing bar must be used
as the roller has no brakes.
The roller must be towed slowly, max. 3 km/h (2
mph) and only towed short distances, max. 300 m
(330 yards). The roller must be towed slowly, max. 3 km/h (2
mph) and only towed short distances, max. 300 m
(330 yards).
Fig. Towing
When towing/retrieving a machine, the towing device
must be connected to both lifting holes in the diagram.
The load is uniformly divided between the two lugs.
The pulling forces should act parallel to the machine's
longitudinal axis, as shown in the figure. See table
below for maximum permitted pulling force.
Model kN lbf Model kN lbf
CC224-384, CC2200-3800 140 31 500 CC224-384, CC2200-3800 140 31 500
CC424-624, CC4200-6200 190 42 750 CC424-624, CC4200-6200 190 42 750
Reverse the towing preparations made to the
hydraulic pump and/or the motor. Reverse the towing preparations made to the
hydraulic pump and/or the motor.
85