Fayat Group DYNAPAC CC224C, Instruction Manual

Page: 137 / 168

Maintenance measures - 500 h
4812159701_D.pdf 2021-03-16
Air cleaner
- Cleaning
Wipe clean on both sides of the outlet
pipe.
Outer edge of outlet
pipe. Inner edge of
outlet pipe.
Wipe clean the inside of the cover (2) and the filter
housing (5). See the previous illustration.
Wipe also both surfaces for the outlet pipe; see
adjacent figure.
Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine. Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine.
Drum - oil level
Inspection - filling
Fig. Drum, vibration side
1. Filler plug
2. Level plug
2
1
Position the roller with the filler plug (1), the large plug,
at the highest point in its rotation.
Wipe clean around the level plug (2), the small plug,
and remove the plug.
Make sure that the oil level is up to the lower edge of
the hole. Top off with fresh oil if the level is low. Use oil
as specified in the lubricants specification.
When removing the filler plug, wipe any metal
accumulated on the plug magnet off. Make sure that
plug seals are intact and replace with new seals if not.
Refit the plugs and check that they are tight by driving
the roller and then rechecking.
125