Fayat Group DYNAPAC CA1500, Instruction Manual, Page: 121 / 168

Maintenance, first 50h
4812159201_F.pdf 2019-10-21
Tires - Air pressure - Wheel nuts - Tightening
Fig. Wheels
1. Air valve
2. Wheel nut
1
2
Check the tire pressures using a pressure gauge.
If the tires are filled with fluid, the air valve (1) must be
in the "12 o'clock" position during pumping.
Recommended pressure: See Technical
Specifications.
Check the tire pressure.
When changing the tires it is important that both
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
anti-slip in the rear axle. When changing the tires it is important that both
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
anti-slip in the rear axle.
Check the tightening torque of the wheel nuts (2) at
630 Nm (465 lbf.ft).
Check both wheels and all nuts. (This only applies to a
new machine or newly fitted wheels).
Check the safety manual that accompanies the
roller before filling the tires with air. Check the safety manual that accompanies the
roller before filling the tires with air.
Drum gear - Oil change
Fig. Oil change - drum gear
1. Drum gear
1
Place the roller on a level surface so the
drain/ventilating plugs are in location for drain.
Wipe clean, unscrew the plugs (2, 3) and drain the oil
into a suitable receptacle, capacity about 2 liters (0.5
gal.).
Fig. Drum gear
3
2
109