Fastech Ezi-Step II Plus-E, User Manual

Page: 22 / 68

www.fastech.co.kr
External Name and Function Setting of Ezi-STEPⅡ Plus-E
22
Ethernet status LED ５－４．
1) This LED indicates the Ethernet communication status. The Link1 / Link2 LEDs are located
on the top right of each Ethernet connector, and the Activity LED is on the top left.
IP Address selection switch (SW1, SW2) ５－５．
1) It can be set from "1 to 254". Please set IP not to overlap.

"0" and "255" cannot be used for IP setting. Be sure to set it to "1 to 254"..

The default gateway is 192.168.0.1. When the switch is set to "1"
Change Gateway. Refer to the [Manual - User Program 2-4] section for the change method.
If the IP address and gateway are the same, Alarm (201 or 202) occurs.

It is recommended to use "2 ~ 254" for IP setting. (Default: SW1: 2, SW2: 0)
2) Basic set is “192.168.0.xxx”, and xxx are set by switch.
Ex.) In case of SW1 : 9, and SW2 : 6
9 * 1 + 6 * 16 = 105
IP address : 192.168.0.105 (7-Segment display : 69)
3) If set to switch as 255(FF), IP Address is setting automatically.
Because it uses DHCP, IP address is set automatically only when using router.
(Connect the Ethernet to Ethernet IN connector)

When connecting directly to the controller (PC/PLC), it need to be sure to set the OP address
with switch

Set the IP address automatically only when you do not use the default IP address. If IP is set
automatically, connect the user program (GUI) and save the IP address. And turn off the power
and set the lasr number of IP with switch

When the switch is set to 0, the IP setting becomes the initial (default) value.
In the initial state, communication is not connected.

Basic IP Address : 192.168.0.xxx, Subnet Mask : 255.255.255.0, Gateway : 192.168.0.1
Name Color Status Description
Error Red
OFF Normal status or Power OFF
Single Flash Local Error
LK1/
LK2
Green
OFF Link deactivated
ON Link activated
Activity Yellow
OFF Non operation
Flickering In operation