![background image](http://html.mh-extra.com/html/farmtek/112534/112534_manual_545402008.webp)
8
112534 Revision date: 05.13.20
1. Connect two pieces of the WF4140 1-1/2" pvc using one WF1982 coupling. Seal joint using pvc primer and cement and allow to dry.
2. With assistance, snap a chalk line along the top, center of the pvc assembly to mark the drain hole positions from end-to-end.
1
MARK AND DRILL BUCKET DRAIN HOLES
Required Tools:
• Drill with a 1" hole saw. Example shows using a
step bit. Keep holes aligned and uniform.
• Marker, chalk line, and tape measure
3. Next measure 9" in from one end and mark the position on the chalk line.
4. From the 9" line measure 18" and mark that position.
5. Continue marking hole locations at 18" intervals working toward the other end of the drain tube. Mark twelve (12) hole locations in all–one for each Dutch
bucket in the first row.
6. Take a 1" hole saw and drill the 12 drain holes in the pvc drain tube. Keep all holes aligned and centered on the chalk line.
7. After drilling the holes, clean all debris from inside the drain tube and from around the drain holes.
8. Take one MH1123 slip cap and slide it over the end of the drain tube assembly. Do not cement the cap. It is removed when drain tube is cleaned.
9. Repeat these steps to create the remaining drain tube assembly.
Complete these steps:
STEP 8
DO NOT CEMENT CAP.
MH1123
Slip Cap
Drain T
ube
18"
9"
18"
Spacing for 1" Holes
WF4140 PVC Tube
WF1982 Coupling — Seal using pvc primer and cement.
Chalk Line
Capped
End
Drain
End
Assembly Instructions—Drain Tube Preparation