Farm King BW200, Operator And Parts Manual

Page: 44 / 82

Maintenance - 200 Bale Wrapper
42
LUBRICATION
Always use a good quality multi-purpose / lithium
base grease when lubricating the equipment.
• Always use a hand-held grease gun.
• Clean fitting before greasing, to avoid injecting
dirt and grit.
• Replace and repair broken fittings immediately.
• If fittings will not take grease, remove and clean
thoroughly. Replace fitting if necessary.
IMPORTANT
Fluid such as engine oil, hydraulic fluid,
coolants, grease, etc. must be disposed of in an
environmentally safe manner. Some regulations
require that certain spills and leaks on the ground
must be cleaned in a specific manner. See local,
state and federal regulations for the correct
disposal.
Figure 22
Lubrication point symbol is shown [Figure 22] .
REGULAR INSPECTION
After every use of the wrapping machine, check:
• Condition and legibility of the data plate and
symbols
• Condition of the draw bar
• Hydraulic system leaks
• Drive chain of the rotary frame
• Drive chains of the rotary drums
The nameplate must only be replaced at an
authorized repair shop. Replace any unintelligible
symbols with new ones.
After the working season is over, grease the drive
chain of the rotary frame and the drive chains of
the rotary drums using the LT-43 grease.
IMPORTANT
Send the counter to an authorized service if the
casing is damaged. Any attempt to repair the
damaged counter will result in the warranty
becoming null and void.
Replace the oil of the intersecting axis gear every
two years as follows:
• Place the machine on a level surface
• Place a leak proof tank below the drain plug
• Remove the drain plug, the filler plug and the
overflow plug
• After the oil is drained, close the drain plug
• Pour fresh 80W90 hydraulic gear oil to the filler
plug level
• Close the filler plug and overflow plug